Filter
Top Products
3-47
Programming
Lists of Commands
:SENSe:CORRection:ELEVation Sets the elevation value used by the instrument to
compensate for air dispersion.
I
:SENSe:CORRection:OFFSet:MAGNitude Sets the power offset value used by the instrument. S
:SENSe:CORRection:MEDium Sets the instrument to return the wavelength reading in a
vacuum when the parameter is on. Parameters are VAC
and AIR.
I
:SENSe:DATA? Queries the time domain samples of the input signal. I
STATus Subsystem
:STATus:{OPERation | QUEStionable}:CONDitio
n?
Returns the value for the condition register for the node. S
:STATus:{OPERation | QUEStionable}:EVENt? Returns the value of the event register for the node. S
:STATus:{OPERation | QUEStionable}:ENABle Sets the enable register. S
:STATus:{OPERation | QUEStionable}:PTRansit
ion
Sets the positive transition filter register. S
:STATus:{OPERation | QUEStionable}:NTRansit
ion
Sets the negative transition filter register. S
:STATus:PRESet Presets the enable registers for all status nodes. S
SYSTem Subsystem
:SYSTem:ERRor? Queries an error from the error queue. S
:SYSTem:HELP:HEADers? Queries an ASCII listing of all Agilent 86120C remote
commands.
I
:SYSTem:PRESet Performs the equivalent of a front-panel PRESET key
press.
S
:SYSTem:VERSion Queries the version of SCPI with which this instrument is
compliant.
S
TRIGger Subsystem
:ABORt Stops the current measurement sequence. S
:INITiate:IMMediate Places the instrument into the initiated state and initiates
a new measurement sequence.
S
:INITiate:CONTinuous Sets the instrument for single or continuous
measurement.
S
UNIT Subsystem
:UNIT[:POWer] Sets the power units to watts (linear) or dBm (logarithmic). S
Table 3-10. Programming Commands (5 of 5)
Command Description Code
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.