Filter
Top Products
4-40
Programming Commands
CALCulate2 Subsystem
WLIMit:STARt:WNUMber
Sets the starting wavenumber for the wavelength limit range.
Syntax
:CALCulate2:WLIMit:STARt:WNUMber {?|{<real> | MINimum | MAXimum}}
<real> is a wavenumber value that is within the following limits:
Constant
Description
MINimum 6060 cm
-1
(1650 nm)
MAXimum wavelength limit stop value
Attribute
Summary
Non-sequential command
Preset State: 6.060606E5 m
-1
*RST State: 6.060606E5 m
-1
SCPI Compliance: instrument specific
Description This command sets the starting range for the wavelength limit. The
default units for the <real> parameter value are m
-1
. The start wave-
number value must be less than or equal to the stop wavenumber
value or the start wavenumber will be clipped to the stop wavenumber
and a “Data out of range” error will be generated.
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that this command has
the time to complete before sending any more commands to the instrument. Refer
to “Always force the Agilent 86120C to wait for non-sequential commands” on
page 3-12 for more information.