Filter
Top Products
4-56
Programming Commands
CALCulate3 Subsystem
DRIFt:DIFFerence[:STATe]
Sets the drift calculation to subtract the minimum values measured
from the maximum values measured.
Syntax
:CALCulate3:DRIFt:DIFFerence[:STATe]{?| {ON | OFF | 1 | 0}}
Attribute
Summary
Preset State: off
*RST State: off
SCPI Compliance: instrument specific
Description Use the CALC3:DRIF:PRES command to turn off all the drift states
before turning on this state. The CALC3:DATA? query returns the max-
imum power and frequency minus the minimum power and frequency.
Note
Only one STATe command can be turned on at any one time. Attempting to turn
more than one state on at a time results in a “–221 Settings Conflict” error. Refer
to “Measure delta, drift, and signal-to-noise” on page 3-14 for additional informa-
tion on selecting measurements.