Filter
Top Products
The HBAnyware Utility User Manual Page 113
SetAuthConfig
Syntax: hbacmd SetAuthConfig <WWPN1> <WWPN2> <PasswordType> <Password> <Parameter>
<Value>
Description: Sets the authentication configuration for the HBA.
Parameters:
WWPN1 - World Wide Port Name of the HBA whose authentication configuration you wish to set
WWPN2 - Must be ff:ff:ff:ff:ff:ff:ff:ff
PasswordType - 1 = ASCII, 2 = Hex (binary), 3 = Password not yet defined
Password - Current password value
Parameter - Parameters include Mode, Timeout, Bi-directional, Hash-priority, DH-priority, Re-
authentication, Re-authentication-interval
Value - Parameter-specific value: Mode = <disabled, enabled, passive>, Timeout = time in seconds, Bi-
directional = <disabled, enabled>, Hash-priority = <md5, sha1> (md5 = first md5, then sha1; sha1 = first
sha1, then md5), DH-priority = <1,2,3,4,5>, any combination up to 5 digits, Re-authentication =
<disabled, enabled>, Re-authentication-interval = < 0, 10 - 3600>
SetPassword
Syntax: hbacmd SetPassword <WWPN1> <WWPN2> <Flag> <Cpt> <Cpw> <Npt> <Npw>
Description: Sets the password for the HBA.
Parameters:
WWPN1 - World Wide Port Name of the HBA for which you wish to set a password.
WWPN2 - Must be ff:ff:ff:ff:ff:ff:ff:ff
Flag - 1 = Local (password used by HBA when HBA authenticates to the switch), 2 = Remote (password
used by HBA when switch authenticates to the HBA)
Cpt - Current password type is 1 = ASCII or 2 = Hex (binary), 3 = Password not yet defined
Cpw - Current password value
Npt - New password type is 1 = ASCII or 2 = Hex (binary)
Npw - New password value
DeleteAuthConfig
Syntax: hbacmd DeleteAuthConfig <WWPN1> <WWPN2> <PasswordType> <Password>
Description: Deletes the authentication configuration on the HBA.
Parameters:
WWPN1 - World Wide Port Name of the HBA whose authentication configuration you wish to delete
WWPN2 - Must be ff:ff:ff:ff:ff:ff:ff:ff
PasswordType - 1 = ASCII, 2 = Hex (binary), 3 = Password not yet defined
Password - Current password value