Filter
Top Products
The HBAnyware Utility User Manual Page 55
auth-keys Controller
Specific
Description and Values: This is the DH-CHAP authentication key driver
property for FC-SP support. It is only valid when driver property enable-auth
is set to 1. This driver property should be ignored when enable-auth is set to
0. The format of this property is like:
"LWWN:ktype:klength:key:RWWN:ktype:klength:key"
LWWN: The WWPN of the local entity, i.e. HBA port. You should use the
form of NNNNNNNNNNNNNNNN, where NNNNNNNNNNNNNNNN is a 16
digit representation of the Host port WorldWide Port Name. Or you could
use 0000000000000000 to refer to local port WWPN.
ktype: The type of the key. The valid type could be ASCII text format
represented by 0001, or binary format (Hexidecimal input) represented by
0002, or 0003 ignored. When 0003 is used, the corresponding klength and
key are ignored. The format is 4 digit.
klength: The length of the key in bits. The length is represented by
hexidecimal format. For example: 32 bytes of key should be represented by
0100. The maximum size of key is 128 bytes. The minimum size of key is 16
bytes.
RWWN: The WWPN of the remote entity, i.e. Fabric controller or any remote
nport. You should use the form of NNNNNNNNNNNNNNNN, where
NNNNNNNNNNNNNNNN is a 16 digit representation of the Fabric
Controller or nport FFFFFFFFFFFFFFFF as generic remote fabric port
WWPN.
key: The key associated with local entity or remote entity. For example, 16
bytes of key with ASCII type: aabbccddeeffgghh. 16 bytes of key with binary
type:61616262636364646565666667676868.
You can use lpfcX-auth-keys to specify the per HBA instance DH-CHAP
authentication keys. Any valid setup in this way will overwrite the auth-keys
setup.
automap Controller
Specific
1 0=Off 1=On No Automatically assign SCSI
IDs to FCP targets detected. If
automap is 1, SCSI IDs for all
FCP nodes without persistent
bindings will be automatically
generated based on the bind
method of the corresponding
HBA port. If FCP devices are
added to or removed from
the Fibre Channel network
when the system is down,
there is no guarantee that
these SCSI IDs will remain
the same when the system is
booted again. If automap is 0,
only devices with persistent
bindings will be recognized by
the system.
Table 3: LPFC.conf Parameters (Continued)
Property Name Scope Default Min Max Dynamic Comments