Filter
Top Products
The HBAnyware Utility User Manual Page 63
lpfcNtM-tgt-throttle Controller
Specific
none 1 10240 No The maximum number of
outstanding commands to
permit for any target, including
all LUNs on that target. This
value overrides tgt-queue-
depth.
lpfcXtYlZ-lun-mask Controller
Specific
none 0 1 Yes The driver uses this value to
determine whether or not to
expose discovered LUNs to
the OS. When set to 1, the
discovered LUN is masked
and not reported to the OS.
When set to 0, the discovered
LUN is reported to the OS.
lpfcX-lun-unmask Controller
Specific
none 0 1 Yes The driver uses this value to
determine whether to override
the LUN masking or not.
When set to 1, all LUNs on all
targets on the specified lpfc
instance are reported to the
OS regardless of their
respective lunmask settings.
When set to 0 (default), the
override is not in effect.
lpfcXtY-lun-
unmask
Controller
Specific
none 0 1 Yes The driver uses this value to
determine whether to override
the LUN masking or not.
When set to 1, all LUNS on a
specified target are reported
to the OS regardless of their
respective lunmask settings.
When set to 0 (default), the
override is not in effect.
lun-queue-depth Global 30 1 128 No The driver uses this value as
the default limit for the number
of simultaneous commands to
issue to a single logical unit
on a single target on the loop.
A single logical unit will never
be sent more commands than
allowed by lun-queue-depth;
however, less may be sent
when sd-max-throttle or
tgt-queue-depth is reached
for the entire target.
Table 3: LPFC.conf Parameters (Continued)
Property Name Scope Default Min Max Dynamic Comments