Filter
Top Products
The HBAnyware Utility User Manual Page 77
Driver for Linux, LPFC and LPFCDFC Parameter Tables
The driver parameter values listed in Table 3 are applicable to driver version 8.0.16.34 or later. If you
are using a version previous to 8.0.16.34, see the Emulex Driver for Linux User Manual for parameter
information
The parameters determine some aspects of the driver behavior. The following tables list the driver
parameters. Some driver parameters can be modified and take effect only on a driver load while others
can be modified dynamically and take effect immediately. The tables also list the default, minimum and
maximum values for these parameters.
In Table 6, driver parameters marked with an asterisk are not supported by HBAnyware. You can change
them via LPFC. See the Driver User Manual for more Information.
Table 6: Driver for Linux, LPFC Static Parameters (Requires a driver reload to change)
Variable Default Min Max Comments
Visible
using
sysfs
lpfc_ack0 0 0=Off 1=On Use ACK0 for class 2. Yes
lpfc_cr_count 1 1 255 This parameter determines
the values for I/O
coalescing for cr_delay
(msec) or cr_count
outstanding commands.
No
lpfc_cr_delay 0 0 63 This parameter determines
the values for I/O
coalescing for cr_delay
(msec) or cr_count
outstanding commands.
No
lpfc_discovery_threads 32 1 64 Specifies the maximum
number of ELS commands
that can be outstanding for
a discovery.
Note: The
discovery_threads
parameter will default to a
value of 64 for private loop
topologies regardless of the
configured value. If there
are multiple ports
configured on the host the
value of 64 will only be
used for those ports that
are connected in a private
loop topology. The
configured value will be
used for all other ports.
No
lpfc_fcp_class 3 2 3 Fibre Channel class for
FCP data transmission.
Yes