Filter
Top Products
The HBAnyware Utility User Manual Page 56
cr-count Controller
Specific
1 1 255 No This value specifies a count of
I/O completions after which an
interrupt response is
generated. This feature
is disabled if cr-delay is set to
0.
cr-delay Controller
Specific
0 0 63 No This value specifies a count of
milliseconds after which an
interrupt response generated
if cr-count has not been
satisfied. This value is set to 0
to disable the Coalesce
Response feature as default.
delay-rsp-err Controller
Specific
0 0=Off 1=On Yes (Boolean) The driver will delay
FCP RSP errors being
returned to the upper SCSI
layer based on the no-device-
delay configuration driver
property.
discovery-threads Controller
Specific
1 1 32 No Number of ELS commands
during discovery. This value
specifies the number of
threads permissible during
device discovery. A value of 1
serializes the discovery
process.
Table 3: LPFC.conf Parameters (Continued)
Property Name Scope Default Min Max Dynamic Comments