The HBAnyware Utility User Manual Page 82
Mapping and Masking
Automapping SCSI Devices (Windows)
The driver defaults to automatically mapping SCSI devices. The procedures in this section apply if the
default has been changed.
To automap SCSI devices:
1. Display driver parameters for the host or HBA - select the Driver Parameters tab or the host
Driver Parameters tab.
2. Select the AutoMap HBA parameter. Several fields about the parameter appear on the right
side of the screen.
3. Select Enabled.
4. If you want a temporary change (where the parameter reverts to its last permanent setting when
the system reboots), check Make changes temporary box. This option is available only for
dynamic parameters.
5. If you need to make changes to multiple parameters, and you want all the changes temporary,
check Make all changes temporary box. Only dynamic parameters can be temporary.
6. To apply your changes, click Apply.
7. Reboot the system for this change to take effect.
Mapping and Masking Defaults (Windows)
Table 10 describes LUN mapping and masking global defaults.
Table 10: Mapping and Masking Window Defaults
Field (Function) Default Description Window
Globally Automap
All Targets
Enabled Emulex driver detects all FC devices attached to the Emulex
HBAs.
Global
Automap
Globally Automap
All LUNs
Enabled Assigns an operating system LUN ID to a FC LUN ID for all
LUNs behind all targets in the system area network.
Global
Automap
Globally Unmask
All LUNs
Enabled Allows the operating system to see all LUNs behind all
targets.
Global
Automap
Automap All
LUNs (Target
Level)
Disabled With Globally Automap All LUNs disabled, this parameter
assigns an operating system LUN ID to a FC LUN ID for all
LUNs behind the selected target.
LUN Mapping
LUN Unmasking
(Target Level)
Disabled Allows the operating system to see all LUNs behind the
selected target. With this parameter disabled, each
individual LUN can be masked or unmasked.
LUN Mapping