Filter
Top Products
The HBAnyware Utility User Manual Page 75
num-iocbs Min:128
Max:1024
Default = 10240
Description: Sets the
number of iocb buffers to
allocate.
num-bufs Min:128
Max:10240
Default = 256
Description: Specifies the
number of command buffers
to allocate. These buffers
are used for Fibre Channel
Extended Link Services
(ELS) and one for each FCP
command issued in SLI-2
mode. If you want to queue
lots of FCP commands to the
adapter, then you should
increase num-bufs for better
performance. These buffers
consume physical memory
and are also used by the
device driver to process loop
initialization and rediscovery
activities. Important: The
driver must always be
configured with at least
several dozen ELS
command buffers; Emulex
recommends at least 128.
num-nodes Min:2
Max:512
Default:512
Description: Number of FC
nodes (NPorts) the driver
will support.
N/A N/A
pci-max-read Min: 512
Max: 4092
Default: 2048
Description: Sets the PCI-X
max memory read byte
count [512, 1024, 2048 or
4096].
N/A N/A
pm-support 0 = Disables power
management support in the
driver.
1 = Enables power
management support in the
driver.
Default: 0
Description: Enable/Disable
power management support
in the driver
N/A N/A
Table 5: Solaris SFS and Solaris LPFC Driver Parameter Cross-Reference (Continued)
Solaris SFS/
HBAnyware
Parameter
Solaris SFS/HBAnyware
Min/Max, Defaults and
Description
Related
LPFC
Parameter
LPFC Min/Max, Default and
Description
Comments