Filter
Top Products
The HBAnyware Utility User Manual Page 91
Creating an ASG
Create a new Access Sub-Group (ASG) by selecting one system from the Access Control Group (ACG)
to be the client, and some or all of the other systems to be servers to this client, thus defining the new
client's ACG. When the HBAnyware Security Configurator is run on the new client, the ACG shows the
servers that were configured in the ASG by its parent client.
To create an ASG:
1. Click the Access Sub-Groups tab.
Figure 45: Access Sub-Groups tab with No Sub-Groups Created
2. Click New. The New Access Sub-Group dialog box appears:
Figure 46: New Access Sub-Group dialog box
3. Enter the ASG information:
• Access Sub-Group Name: Enter the name of the ASG. The ASG name is for identifica-
tion purposes only. It does not provide any security function. Provide a name that will
make it easy to remember the systems that are part of the ASG. The name can contain
any alphanumeric characters, symbols or spaces (up to 31). At each level of the security
topology, each ASG name must be unique. If the name is not unique at its level, an error
message informs you of this when you click OK.
• Access Sub-Group Client System: Select the system that is to be the client.
• Number of indices reserved for this Access Sub-Group: Select the number of 'indices'
you want to reserve for the client system of the new ASG. This number reflects the num-
ber of subsequent 'child' ASGs that you can subsequently create on the new client's
system.
4. Click OK in the New Access Sub-Group dialog box. The ASG is created.