Filter
Top Products
The HBAnyware Utility User Manual Page 70
network-on 0 0 1 Requires
reboot.
Enables/disables IP
networking support in
the driver.
num-iocbs 1024 128 10240 Requires
HBA reset.
This variable indicates
the number of Input/
Output control block
(IOCB) buffers to
allocate.
num-nodes 0
0 4096 Requires
HBA reset.
Number of FC nodes
(NPorts) the driver will
support.
pci-max-read 2048
512 4096 Requires
HBA reset
Sets the PCI-X max
memory read byte
count [512, 1024,
2048 or 4096]
pm-support 0 = Disables
power
management
support in
the driver.
0 1 = Enables
power
management
support in the
driver.
Requires
reboot.
Enable/Disable power
management support
in the driver.
ub-bufs
1000 40 16320 Requires
reboot.
Sets the number of
unsolicited buffers to
be allocated.
topology 0 0 =loop , then P2P
2 =P2P only
4 =loop only
6 =P2P, then loop
Requires
link reset.
Set to point-to-point
mode if you want to
run as an N_Port. Set
to loop mode if you
want to run as an
NL_Port.
Table 4: emlxs.conf Parameters (Continued)
Property
Name
Default Min Max Activation Comments