Filter
Top Products
The HBAnyware Utility User Manual Page 115
PostTest
Syntax: hbacmd PostTest <WWPN>
Description: Runs the POST on the HBA. Support for a remote HBA is TCP/IP access only.
Parameters:
WWPN - World Wide Port Name of the HBA on which you wish to run a POST
EchoTest
Syntax: hbacmd EchoTest <WWPN Source> <WWPN Destination> <Count> <StopOnError> <Pattern>
Description: Runs the echo test on HBAs.
Parameters:
Source WWPN - World Wide Port Name of the originating HBA
Destination WWPN - World Wide Port Name of the destination (echoing) HBA
Count - Number of times to run the test. 0 = run test infinitely
StopOnError - Should the test be halted on Error? 0 = No halt, 1 = Halt
Pattern - Hexadecimal data pattern to transmit (up to 8 characters)
Loopback
Syntax: hbacmd loopback <WWPN> <Type> <Count> <StopOnError> <Pattern>
Description: Runs the loop test on the HBA specified by the WWPN.
Parameters:
WWPN - World Wide Port Name of the HBA on which you wish to run loopback
Type - 0 = PCI LoopBack Test, 1 = Internal LoopBack Test, 2 = External LoopBack Test
Count - Number of times to run the test (0 = run test infinitely, Range = 1...99,999)
StopOnError - Should the test be halted on Error? 0 = No halt, 1 = Halt
Pattern - Hexadecimal data pattern to transmit (up to 8 characters)
Dump
Syntax: hbacmd dump <WWPN>
Description: Displays the maximum number of diagnostic dump files that be can stored for an HBA.
Creates a diagnostic dump file in the hbacmd dump file directory.
Parameters:
WWPN - World Wide Port Name of the HBA whose dump information you wish to view
Note: Support for remote HBA is TCP/IP access only. The EchoTest command will fail if the
target WWPN does not support the ECHO ELS command.
Note: Only external loopback tests must be run with TCP/IP access.