Filter
Top Products
2/8 BCN-C22005-639
1.2 IPM motor control setting by selecting the parameter setting mode on the
operation panel ( )
POINT
· The parameters required to drive an IPM motor are automatically changed as a batch. (Refer to page 3.)
Operation
example
Initialize the parameter setting for a premium high-efficiency IPM motor (MM-THE4 (1500r/min)
specification) by selecting the parameter setting mode on the operation panel.
Setting Description
0 Parameter settings for a general-purpose motor
1 Parameter settings for a high-efficiency IPM motor MM-EF(rotations per minute)
12
Parameter settings for a premium high-efficiency IPM motors MM-EFS and MM-THE4
(rotations per minute)
22, 32 For manufacturer setting. (Do not set.)
REMARKS
· Performing IPM parameter initialization by selecting the parameter setting mode on the operation panel automatically
changes the Pr. 998 IPM parameter initialization setting.
· The IPM parameter setting is displayed as "1 or 12" in the parameter setting mode even if Pr. 998 IPM parameter
initialization = "101 or 112."
Display
Operation
4. Displaying the setting
Press to read the currently set value.
" " (initial value) appears.
2. Parameter setting mode
Press to choose the parameter setting
mode.
The parameter
number read
previously appears.
3.
Selecting the parameter
1. Screen at power-ON
The monitor display appears.
Flicker ... Parameter setting complete!!
6. Parameter setting
Press to set.
Turn to read another parameter.
Press twice to show the automatic parameter setting (AUTO).
Press to show the setting again.
P.RUN indicator is lit.
5. Selecting the setting
Turn to change it to the set value " ".
Turn until (IPM parameter
initialization) appears.
bcnc22005639.fm 2 ページ ２０１２年１１月２０日 火曜日 午後２時４７分