Filter
Top Products
31
Connection of stand-alone option units
2
INSTALLATION AND WIRING
(2) Connection with the MT-BU5 (75K or higher)
After making sure that the wiring is correct, set the following parameters:
⋅ Pr. 30 Regenerative function selection = "1"
⋅ Pr. 70 Special regenerative brake duty = "10%"
<Inserting the CN8 connector>
Make cuts in rubber bush of the upper portion of the inverter and lead a cable.
1) Make cuts in the rubber bush for leading the CN8 connector cable with a nipper or cutter knife.
2) Insert a connector on the MT-BU5 side through a rubber bush to connect to a connector on the inverter side.
*1 When the power supply is 400V class, install a step-down transformer.
*2 The wiring length between the resistor unit and brake resistor should be 10m maximum when wires are
twisted and 5m maximum when wires are not twisted.
CAUTION
⋅ Install the brake unit in a place where a cooling air reaches the brake unit heatsink and within a distance of the cable supplied
with the brake unit reaches the inverter.
⋅ For wiring of the brake unit and inverter, use an accessory cable supplied with the brake unit. Connect the main circuit cable to
the inverter terminals P/+ and N/- and connect the control circuit cable to the CN8 connector inside by making cuts in the
rubber bush at the top of the inverter for leading the cable.
⋅ The brake unit which uses multiple resistor units has terminals equal to the number of resistor units. Connect one resistor unit
to one pair of terminal (P, PR).
CAUTION
Clamp the CN8 connector cable on the inverter side with a wire clamp securely.
♦ Parameters referred to ♦
Pr.30 Regenerative function selection Refer to Chapter 4 of the Instruction Manual (Applied)
Pr.70 Special regenerative brake duty Refer to Chapter 4 of the Instruction Manual (Applied)
MC
R/L1
Motor
M
Inverter
Brake unit
MT-BU5
Resistor unit
MT-BR5
S/L2
T/L3
U
V
P/+
N/
P
PR
P
PR
P
PR
P
TH1
TH2
PR
CN8
W
Three-phase
A
C power
supply
MCCB
TH1
TH2
MC
OFFON
MC
CR1 CR2
CR1
CR2
T *1
10m or
less
*2
Rubber bushes
Make cuts in
rubber bush
Insert the connector until
you hear a click sound.
CN8 connector
Wire clamp