Filter
Top Products
82
Initial value change list
5.9 Initial value change list
Displays and sets the parameters changed from the initial value.
Operation Display
1.Screen at power-ON
The monitor display appears.
2.Operation mode setting
Press to choose the PU operation mode.
PU indicator is lit.
3.Press to choose the parameter setting
mode.
PRM indicator is lit.
(The parameter number read previously appears.)
4.Turn until appears.
5.Pressing changes to the initial value
change list screen.
6.Turning displays the parameter number
changed.
Press to read the present set value.
Turn and press to change the
setting
(refer to step 6 and 7 on page 51)
Flicker ··· Frequency setting complete!!
Turn to read another parameter.
The display returns to after all
parameters are displayed.
7.Pressing in status returns to
the parameter setting mode.
Turning sets other parameters.
Pressing displays the change list again.
REMARKS
Calibration parameters (C0 (Pr. 900) to C7 (Pr. 905), C42 (Pr. 934) to C45 (Pr. 935)) are not displayed even they are changed from
the initial settings.
Only simple mode parameter is displayed when simple mode is set (Pr. 160 = 9999 (initial value))
Only user group is displayed when user group is set (Pr. 160 = "1").
Pr. 160 is displayed independently of whether the setting value is changed or not.
PU EXT NET
SET
SET
SET SET
SET
SET
SET
SET
SET