Filter
Top Products
83
Parameter list
5
ADJUSTMENT
5.10 Parameter list
5.10.1 List of parameters classified by the purpose
Set the parameters according to the operating conditions.
The following list indicates purpose of use and corresponding parameters.
Purpose of Use Function (Parameter Number) Page
Acceleration/deceleration time/pattern adjustment — Acceleration/deceleration patterns and backlash measures (Pr.29, Pr.140 to
Pr.143)
91
Acceleration/deceleration time/pattern adjustment — Acceleration/deceleration time setting (Pr.7, Pr.8, Pr.20, Pr.21, Pr.44, Pr.45,
Pr.147, Pr.791, Pr.792)
88
Acceleration/deceleration time/pattern adjustment — Regenerative avoidance operation (Pr.665, Pr.882 to Pr.886)
112
Acceleration/deceleration time/pattern adjustment — Starting frequency (Pr.13, Pr.571)
89
Adjusting the output torque (current) of the motor — Manual torque boost (Pr.0, Pr.46)
87
Adjusting the output torque (current) of the motor — Simple magnetic flux vector control (Pr.90)
98
Adjusting the output torque (current) of the motor — Simple magnetic flux vector control and IPM motor control (Pr.80)
98
Adjusting the output torque (current) of the motor — Slip compensation (Pr.245 to Pr.247)
106
Adjusting the output torque (current) of the motor — Stall prevention (Pr.22, Pr.23, Pr.48, Pr.49, Pr.66, Pr.148, Pr.149, Pr.154,
Pr.156, Pr.157)
90
Communication operation and command source — Selection of the NET operation mode command source (Pr.550)
108
Communication operation and command source — Selection of the PU operation mode command source (Pr.551)
108
Communication operation and setting — Control of parameter write by communication (Pr.342)
108
Communication operation and setting — Control of parameter write by communication (Pr.342)
99
Communication operation and setting — Initial setting of RS-485 communication
(Pr.117 to Pr.124, Pr.551)
99
Communication operation and setting — Initial setting of RS-485 communication (Pr.331 to Pr.343, Pr.502, Pr.539,
Pr.549 to Pr.551, Pr.779)
108
Detection of output frequency and current — Detection of output current (Y12 signal) and zero current (Y13 signal) (Pr.150
to Pr.153, Pr.166, Pr.167)
103
Detection of output frequency and current — Detection of output frequency (SU, FU, and FU2 signals)
(Pr.41 to Pr.43, Pr.50, Pr.870)
92
Energy saving operation — Energy saving control selection (Pr.60)
95
Frequency setting by analog input — Analog input selection, override function, analog input compensation (Pr.73,
Pr.242, Pr.243, Pr.252, Pr.253, Pr.267)
96
Frequency setting by analog input — Bias and gain for the frequency setting voltage (current) (Pr.125, Pr.126,
Pr.241, C2(Pr.902) to C7(Pr.905))
100
Frequency setting by analog input — Noise elimination at the analog input (Pr.74)
97
Frequency setting with terminals (contact input) — Compensation of multi speed and remote setting inputs (Pr.28)
90
Frequency setting with terminals (contact input) — Jog operation (Pr.15, Pr.16)
89
Frequency setting with terminals (contact input) — Multi-speed setting operation
(Pr.4 to Pr.6, Pr.24 to Pr.27, Pr.232 to Pr.239)
87