Taylor 047772-M Freezer User Manual


 
19
Model PH90 Important: To the Operator
The next display is the screen which will appear after
the failure message. To comply with health codes, heat
treatment system freezers must complete a heat
treatment cycle daily, and must also be brushed
cleaned every 14 days. Brush cleaning is the normal
disassembly and cleaning procedure. Failure to follow
these guidelines will cause the control to lock the
freezer out of the AUTO mode. Press the WASH
keypad.
NO AUTO OPERAT ION
ALLOWED UNTIL
BRUSH CLEANING
PRESS WASH KEY
The next display is the screen which will appear after
the brush cleaning message and illustrates that the
control is i n the OFF mode and the machine needs to
be disassembled and brush cleaned.
Once the unit is unlocked, only the mix out and mix low
LED’s will light.
OFF :MODE: OFF
OK :MIX: OK
41.0F HOPPER 41.0F
FREEZER LOCKED
Soft Lock: If a heat treatment cycle has not been
initiated within the last 24 hours, all four LED’s on the
front of the machine will light and a message will
appear on the LCD. Line 3 of the LCD will indicate the
reason the message appears. Following are the
variable messages which will appear on line 3:
1. POWER SWITCH OFF: Power switch was in
the OFF position.
2. MIX OUT PRESENT: There was mix out
condition present.
3. AUTO OR STANDBY OFF: The unit was not in
the AUTO or STANDBY mode.
4. NO HEAT CYCLE TRIED: A heat treatment
cycle was not attempted in the last 24 hours.
(AUTO HEAT TIME was advanced, or a power
loss was experienced at the time the cycle was
to occur, or a heat cycle failure not due to a
thermistor failure.)
NO HEAT TREAT START
BECAUSE
VARIABLE MESSAGE
PRESS SEL KEY
If the following screen appears, a soft l ock has
occurred during the heat treatment cycle.
HEAT TREAT CYCLE
FAILURE
FREEZER LOCKED
PRESS SEL KEY
If the temperature of the product has not fallen below
41_F(5_C)by the endof the COOL cycle, thefollowing
screen will appear.
PRODUCT OVER TEMP
FREEZER LOCKED
PRESS SEL KEY
Press the SEL keypad to advance to the next display.
When one of t hese m essages appears, automatic
freezer operation cannot take place until the freezer is
disassembled and brush cleaned or has completed a
heat treatment cycle. The next display will instruct the
operator to start a heat treatment cycle manually (by
pressing the AUTO keypad), or to disassemble and
brush clean the freezer. If the AUTO keypad is
pressed, the freezer will automatically start the heat
treatment cycle and only the heat cycle LED will light.
NO AUTO OPERAT ION
ALLOWED. PRESS
AUTO FOR HEAT CYCLE
WASH TO BRUSH CLEAN