Filter
Top Products
Troubleshooting Guide Model PH9071
Problem Shake Side
Probable Cause
Soft Serve Side
Probable Cause
Either Side
Probable Cause
Corrective Action Page
Ref.
16. Large pressure
adjustments are
necessary to
receive 1 fl. oz.
(30ml.)in5
seconds. (Cont’d.)
d. Plugged syrup
line fitting at
freezer door
connection.
d. Clean the syrup line fitting.
-- -- --
e. Inadequate a ir
pressure to syrup
solenoids.
e. Call service technician.
-- -- --
17. Pump will not
operate i n the
PUMP mode.
a. Pump motor is not
activated.
a. Push the reset button.
-- -- --
b. The membrane
switch is
defective.
b. Call service technician.
-- -- --
18. Machine will not
run when in the
AUTO mode.
a. Machine is
unplugged.
a. Plug into wall receptacle.
-- -- --
b. Beater motor is
out on reset.
b. Clear the tone. Allow the beater
motor to cool. Place the power
switch to OFF. Press the reset
button firmly. Place the power
switch to ON, and press the
W ASH keypad. Open the side
access panel and observe that
the drive shaft is turning
CLOCKWISE as viewed from
the front of the machine. Press
the AUTO keypad to return to
the AUTO mode. If the beater
motor should go OFF on reset
again, call service technician.
15