38
Model PH90Operating Procedures
Step 10
Press the WASH and PUMP keypads and close the
draw valve. (See Figure 59.)
Figure 5 9
Note: Be sure your hands are clean and sanitized
before going on in these instructions.
Step 11
Press the CAL keypad and place the agitator on the
agitator drive shaft housing. (See Figure 60.)
Figure 6 0
Note: If agitator should stop turning during normal
operation, with sanitized hands, remove agitator
from agitator drive shaft housing and brush clean with
sanitizing solution. Install the agitator back onto the
agitator drive shaft housing.
Step 12
Stand the mix feed tube in the corner of the mix hopper.
Place the cotter pin in position in the outlet fitting of the
pump. (See Figure 61.)
Figure 6 1
Step 13
Remove the design cap.
Step 14
Return to the freezer with a small amount of sanitizing
solution. Dip the door spout brush into the sanitizing
solution and brush clean the door spout and bottom of
the draw valve.
Note: To assure sanitary conditions are maintained,
brush clean each item for a total of 60 seconds,
repeatedly dipping the b rush in sanitizing solution.
Install the design cap.
Note: You have just sanitized all food contact
surfaces of the freezer.