52
Model PH90Operating Procedures
Step 14
Remove the discharge tube from the valve body.
(See Figure 106.)
Figure 106
Step 15
Remove the 1--5/16” o--ring from the valve body, and
remove the 1” o--ring from the discharge tube.
CleaningtheSyrupPump
Step 1
Flush and rinse the pump in a container of warm water.
Place the lower end of the pump into the water
container and operate the pump until only warm water
flows from the discharge tube.
Step 2
Remove the pump from the c ontainer of water for
disassembly.
Step 3
W ash and scrub all parts in clean, warm soapy water .
Use the supplied brushes to clean all confined areas.
Step 4
Insert the brush through the tip of the discharge tube.
Move the brush back and forth to scrub the tip of the
discharge tube. (See Figure 107.)
Figure 107
Step 5
Advance the brush completely through the discharge
tube and pull the brush from the bottom of the tube.
Step 6
Insert the brush into the top side of the inlet valve.
Scrub this a rea, specifically around the steel ball.
(See Figure 108.)
Figure 108
Step 7
Insert the brush into the top side of the outlet valve.
Scrub this a rea, specifically around the steel ball.
(See Figure 109.)
Figure 109