Filter
Top Products
Caution
Do not connect a lubricator or lubricated
air to this machine. This machine has a
non-lubricated air circuit.
3M-Matic 800rf Case Sealer Description and Specifications
Copyright 1999, 3M IPC. All rights reserved. 1-3
1-1. Specifications
Tape:
3M brand pressure-sensitive film box sealing tapes.
Tape Width:
Standard 3M-Matic 800rf Case Sealer.
This model offers tape widths from 1-1/2 inches
[36 millimeters] minimum to 2 inches [48
millimeters] maximum.
3M-Matic 800rf-3 Case Sealer.
This model offers 3-inch wide upper and lower
AccuGlide II Taping Heads for tape widths
from 2 inches [48 millimeters] to
3 inches [72 millimeters].
Tape Roll Diameter:
Up to 15-1/2 inches [394 millimeters] maximum, on
a 3-inch [76.2 millimeters] diameter core.
Box Dimensions:
Length: 8 inches [203 millimeters] minimum,
24 inches [610 millimeters] maximum.
Width: 5-1/2 inches [140 millimeters] minimum,
20 inches [508 millimeters] maximum.
Height: 6 inches [152 millimeters] minimum,
20 inches [508 millimeters] maximum.
Box Weight Capacity: (filled)
65 pounds [29 kilograms] maximum; minimum must
be sufficient to hold case on the conveyor bed with
bottom flaps flat.
Box Type:
Box board, 125 to 275 PSI bursting test, single wall
A, B, or C flute.
Operating Conditions:
Use in dry, relatively clean environments at 40
o
F to
120
o
F [5
o
C to 49
o
C] with clean, dry boxes. The
machine should not be washed down or subjected to
conditions causing moisture condensation on compo-
nents.
Machine Specifications:
Length: 86-3/4 inches [2.20 meters].
Width: 57 inches [1.45 meters].
Height: 74 inches [1.88 meters] minimum
with casters to 80 inches [2.03 meters]
maximum with casters.
Weight: Unit uncrated, approximately
1130 pounds [513 kilograms].
Unit crated, approximately
1200 pounds [544 kilograms].
Case sealer bed height: Adjustable up from
factory-set height of 25-7/8 inches
[657 millimeters] to 32 inches
[815 millimeters] with casters.
Power Requirements:
Electrical: 208 to 240 VAC, 50/60 Hz, 5.5 Amps,
3-phase.
Pneumatic: Machine requires 75 140 PSIG
[5.2 9.5 BAR] 7.0 SCFM
[11.89 m
3
/h 21
o
C, 101 kPa] at the
regulator, maximum at maximum
cycle rate.
The optimum operating set point on
the gauge is 95 100 PSIG.
Infeed Conveyor Speed:
The customers infeed conveyor box delivery
speed must not exceed 60 feet/minute.
ü Note
The case sealer accommodates most boxes within the
size range identified above. However, if the ratio of
box length (in the taping direction) to box height is
0.6 or less, several boxes should be test-run to ensure
proper machine performance.
DETERMINE THE BOX LIMITATIONS BY
COMPLETING THIS FORMULA:
Box (tape) Length
Box Height
> 0.6
!