3M-Matic 800rf Case Sealer Installation
Copyright 1999, 3M IPC. All rights reserved. 2-28
23. Remove the mainframe bracket and E-Stop
switch from the rear left of the machine and
install the mainframe bracket at the front right of
the case sealer. Refer to Figure 2-33.
a. Remove 1 socket-head screw securing the
E-Stop switch and bracket to the mainframe
bracket. Set the E-Stop switch aside; it will
be installed later.
b. Remove 6 socket-head screws (6 mm)
securing the mainframe bracket to the case
sealer (4 screws holding the bracket to the
mainframe, and 2 screws holding the bracket
to the two L brackets attached to the under-
side of the door frame).
c. Install this bracket at the front right of the
case sealer. Secure the bracket to the main-
frame and L brackets with 6 socket-head
screws.
Figure 2-33. Moving Support Brackets for Electrical Control Panel
24. Remove the left support bracket from the front
of the machine and install it at the rear left of the
case sealer. Refer to Figure 2-33.
a. Remove 4 socket-head screws (6 mm)
securing the left support bracket to the case
sealer.
b. Install this bracket at the rear left of the case
sealer. Secure the bracket to the mainframe
and L brackets with 6 socket-head screws.
25. Install the Electrical Control Panel at the rear of
the case sealer. This step requires two people.
a. With one person on each side, lift the
Electrical Control Panel from the blocks and
carefully set it onto the support brackets.
b. Hold the control panel in place and secure it
to the support brackets with 4 socket-head
screws.