Filter
Top Products
3M-Matic 800rf Case Sealer Installation
Copyright 1999, 3M IPC. All rights reserved. 2-23
8. Remove the left and right mainframe brackets
that support the Pneumatic Control Panel. Refer
to Figure 2-24.
a. Remove 8 socket-head screws (6 mm)
securing the left support bracket to the case
sealer (4 screws holding the bracket to the
mainframe, and 4 screws holding the 2 L
brackets).
b. Remove 4 socket-head screws (6 mm)
securing the right support bracket to the case
sealer.
c. Save these screws and brackets for use later.
Moving Support Brackets and Installing Pneu-
matic Control Panel
9. Install the left support bracket and L brackets
(removed from the front of the machine) at the
rear of the machine. Refer to Figure 2-25. Secure
the brackets with the socket-head screws (6 mm).
10. Remove the right mainframe bracket from the
rear of the machine and install it at the front left
of the case sealer. Refer to Figure 2-25.
a. Remove the 6 socket-head screws (6 mm)
securing the mainframe bracket to the case
sealer (4 screws holding the bracket to the
mainframe, and 2 screws holding the bracket
to the underside of the door frame).
b. Install this bracket at the front left of the case
sealer. Secure the bracket to the mainframe
with 4 socket-head screws, and secure the
bracket to the underside of the door frame
with 2 socket-head screws.
11. Install the right support bracket (removed from
the front of the machine) at the rear right of the
case sealer. Refer to Figure 2-25. Secure the
bracket to the mainframe with 4 socket-head
screws.
12. Install the Pneumatic Control Panel at the rear of
the case sealer.
a. Lift the Pneumatic Control Panel from the
block and slide it through the undercarriage
to the rear of the case sealer.
b. Block the control panel and then lift it and
carefully set it onto the support brackets.
c. Hold the control panel in place and secure it
to the support brackets with 4 socket-head
screws.
Figure 2-24. Removing Support Brackets for
Pneumatic Control Panel