Filter
Top Products
Preventative Maintenance 3M-Matic 800rf Case Sealer
8-4 Copyright 1999, 3M IPC. All rights reserved.
8-4. Maintenance Schedule
1-1-1. Taping Heads
The following table provides recommendations for
inspecting and replacing parts, and cleaning and
lubricating the upper and lower taping heads.
Taping Head Inspect/Replace Clean Lubricate Counter Cycles *
Centering Rails Inspect at 250 hours. N.A. 250 hours. Every 120,000 cycles.
Closure Chain Replace as needed. Multipurpose
grease.
Infeed Drive Motor Inspect at 250 hours. N.A. 250 hours. Every 120,000 cycles.
Sprockets and Replace as needed. Multipurpose
Chains grease.
Infeed Roller Inspect at 250 hours. N.A. 250 hours. Every 120,000 cycles.
Sprockets and Replace as needed. Multipurpose
Shafts grease.
* Based on an average of 8 cartons/minute. (480 cartons/hour x 250 hours = 120,000 cycles)
8-4-2. Infeed Assembly
The following table provides recommendations for
inspecting and replacing parts, and cleaning and
lubricating the infeed assembly.
Taping Head Inspect/Replace Clean Lubricate Counter Cycles *
Tape Cut-Off Inspect at 250 hours. 250 hours. 250 hours. Every 120,000 cycles
Knife Replace when dull, 3M Natural Cleaner. 3M 5-Way
broken teeth, or poor Penetrant.
cutting.
Knife Oiler Pad Inspect at 250 hours. N.A. 250 hours. Every 120,000 cycles.
Replace when worn, 3M 5-Way
or wont hold sufficient Penetrant.
oil.
Rollers and Shafts Inspect at 250 hours. 250 hours. 250 hours.
Replace as needed. 3M Natural Cleaner. 3M 5-Way Every 120,000 cycles.
Penetrant.
* Based on an average of 8 cartons/minute. (480 cartons/hour x 250 hours = 120,000 cycles)