Filter
Top Products
2-20 Copyright 1999, 3M IPC. All rights reserved.
2-7. Placing 800rf Case Sealer in
Production Line
When installing the 800rf Case Sealer into a produc-
tion line, ensure compliance with the following
requirements:
• The case sealer must be level.
• The customers infeed conveyor may be powered
or inclined to the case sealer.
• The customers infeed conveyor box delivery
speed CANNOT exceed 60 ft/min.
• The customers exit conveyor may be powered or
inclined whichever positively conveys boxes
away from the exit end of the case sealer.
Figure 2-20. Typical Conveyor Setup
• The width of the customers infeed conveyor and
exit conveyor should fall within 22 inches [560
mm] minimum to 38 inches [965 mm] maximum.
Figure 2-20 shows the 800rf Case Sealer connected to
customer-supplied infeed and exit conveyors.
Caution
The 800rf Case Sealer must not be run in a
production line without being joined to the
customers infeed conveyor. This is to
restrict an operator from being exposed to
moving case sealer components during its
operation.
Installation 3M-Matic 800rf Case Sealer
!