3M-Matic 800rf Case Sealer Disassembly/Reassembly
3M 1998 December 4-3
4-4. Side Drive Belt
Warning
Turn off the main air supply and electrical
power before removing any components.
1. Remove the side drive belt assembly using
Procedure 4-3 in this section.
ü Note
If the side drive belt being removed is without pin
and lacing, the belt must be cut to remove it. A
replacement side drive belt with pin and lacing is
needed to reassemble the unit.
5. Install the new drive belt.
6. After installing the new belt, adjust the side
drive belt tension. Refer to Side Belt Tension in
Section 3.
Warning!