Filter
Top Products
Adjustments 3M-Matic 800rf Case Sealer
3-16 Copyright 1999, 3M IPC. All rights reserved.
3-20. Infeed Box Stop-Gate Flow Control-
Speed Control
This cylinder-mounted speed flow control is factory
set and normally does not need adjusting unless the
cylinder is replaced.
Specification
Adjust the Infeed Box Stop-Gate Cylinder speed flow
control for optimum stroke operation. Consider a
smooth cylinder extension without banging or
rebound.
Adjustment
1. Access the Infeed Box Stop-Gate Cylinder from
the underside of the infeed end of the case sealer.
2. Adjust the speed flow control (CW decreases
speed, CCW increases speed).
ü Note
If there is any confusion as to where to set the speed
flow control, turn the adjusting screw fully CW, then
turn the screw 3/4 of a turn CCW. Refer to Table 3-1,
Pneumatic Device Factory Set Points and Adjust-
ment Locations (Cylinder Mounted Speed Controls).