Filter
Top Products
3M-Matic 800rf Case Sealer Installation
Copyright 1999, 3M IPC. All rights reserved. 2-9
2-4-1. Top Tape Head Loading
1. Turn off the Main Disconnect Switch on the
Electrical Control Panel.
2. Insert the tape-threading tool downward around
the rollers, as shown in Figure 2-10.
Figure 2-10. Insert Tape Threading Tool
3. Place the tape roll on the drum to dispense tape
from the bottom of the roll toward the infeed end
of the machine with the tape adhesive-side up.
Attach the tape leading end to the upper end of
the tape-threading tool, as shown in
Figure 2-11.
4. Manually turn the tape roll to create slack tape
while pulling the tape-threading tool through the
tape-applying mechanism until the tool is in
alignment with the applying roller.
Figure 2-11. Attach Tape to Threading Tool
5. Cut off the excess tape with a scissors or knife
below the applying roller. Refer to Figure 2-12.
Retain the tape-threading tool for future use.
Figure 2-12. Cut Off Tape