Filter
Top Products
3M-Matic 800rf Case Sealer Adjustments
Copyright 1999, 3M IPC. All rights reserved. 3-23
3-29. Overload Circuit Breaker
Specification
Adjust the setting screw on the Overload Circuit
Breaker to the 1.4 Amp setting.
Adjustment
Use a Phillips-head screwdriver to set the alignment
mark to the 1.4 Amp setting. Refer to Figure 3-29.
Figure 3-29. Overload Circuit Breaker
Adjustment
3-30. Head Travel Limit Switch
Specification
Adjust the Head Travel Limit Switch located on the
rear head raising cylinder so when the head is at the
rest position, it is approximately 3 inches above the
highest box being run.
Adjustment
1. Loosen the two securing screws. Refer to Figure
3-30.
2. Move the switch up or down as required.
3. Tighten the screws.
4. Check the head rest position.
5. Repeat steps 1 through 4 until the head rest
position is approximately 3 inches above the
highest box being run.
Figure 3-30. Head Travel Limit Switch
Adjustment