Filter
Top Products
6 - 2
6 USING PROGRAM JUMP FUNCTION
iQ Works
6.1 Example of System Configuration
This section explains a method for using the program jump function under the following system configuration.
■ Motion controller start-up programs
The following are the instructions which start motion controller programs used in ladder programs.
• SFCS instruction (Motion SFC program start-up)
• SVST instruction (Servo program start-up)
For details, refer to the following manuals.
Motion controller programming manual of Q173D/Q172D, Q173H/Q172H, and Q173/Q172.
This section explains the program jump function using the following ladder program.
Motion controller (CPU No. 2)
QCPU (CPU No. 1)