Filter
Top Products
3 - 24
3.4.5 Creating AnyWireASLINK configuration diagrams
3 OPERATING PROCEDURE OF MELSOFT NAVIGATOR
iQ Works
3.4.5 Creating AnyWireASLINK configuration diagrams
Create a configuration by placing modules on the AnyWireASLINK Configuration window.
*1: The address of the slave module can be set automatically.
For the address auto-input, refer to the following manual.
GX Works2 Version 1 Operating Manual (Intelligent Function Module)
1. Select AnyWireASLINK master module
(QJ51AW12AL) from the Module List
window, and drag and drop it onto the
Module Configuration window.
The AnyWireASLINK configuration
diagram is created.
2. Double-click "AnyWireASLINK
Configuration" on the Workspace
window to open the AnyWireASLINK
Configuration window.
3. Select the AnyWireASLINK slave
module (B281PB-02U-CC20) from the
Module List window, and drag and drop
it onto the AnyWireASLINK
Configuration window.
The slave module is added on the "list of
modules", and the added slave module is
displayed on the "device map area".
4. Set the address to the added slave
module.
*1
For the general-purpose AnyWireASLINK
module, set the I/O type, address, and
number of occupied I/O points.
Drag & drop
Double click
Drag & drop