Filter
Top Products
3 - 42
3 OPERATING PROCEDURE OF MELSOFT NAVIGATOR
iQ Works
■ Setting multiple CPU parameters
Set multiple CPU parameters by activating the multiple CPU settings of each controller project from
MELSOFT Navigator. Set the parameters on CPU No. 1, and utilize them for CPU No. 2.
The following is an example when utilizing parameters of programmable controller project for a
motion controller project.
For setting parameters on a motion controller project, follow the same procedure as described
below.
1. Select the CPU No. 1 controller on the
Module Configuration window.
2. Select [Q Module Configuration] ⇒
[Parameter] ⇒ [Multiple CPU
Parameter Setting] in the menu bar.
3. The message shown on the left is
displayed.
Read the message and click the
button.
4. GX Works2 is activated and the
message shown on the left is
displayed.
Read the message and click the
button.
(To the next page)
Select
Select