Filter
Top Products
3 - 40
3 OPERATING PROCEDURE OF MELSOFT NAVIGATOR
iQ Works
■ Setting parameters of FX series special adapter
The parameters of special adapters can be set without opening the parameter setting screen of
programmable controller project. The following shows an example when using FX3U-ENET-ADP.
1. Click "FX3U-ENET-ADP" on "FX
module configuration diagram A".
The parameters are displayed on the Input
Detailed Configuration Information window.
2. Set the parameters on the Input
Detailed Configuration Information
window.
Setting example
• Station number: 1
• IP address : 192.168.3.38
• Channel : CH1
3. Set the parameters of "FX module
configuration diagram B" following the
same procedure in the step 1 and step
2.
Setting example
• Station number: 2
• IP address : 192.168.3.39
• Channel : CH1
For the reflection method for the set
parameters to a programmable controller
project, refer to the following section.
■ Reflecting parameters to projects
● Parameter initialization
When "Channel" has already been set to <<PLC System (2)>> tab of PLC parameter in the target program, the
settings of <<PLC System (2)>> tab will be initialized.
To retain the settings in the programmable controller project, backup the project before reflecting the parameters.
Click