Filter
Top Products
Installing Upgrades 103
With the two IDE interface connectors on the system board, your computer
supports up to two IDE devices. IDE hard drives should be connected to
the IDE interface connector labeled “IDE1.” (Always connect CD/DVD
drives to the IDE interface connector labeled “IDE2.”)
Connecting Drives
When you install a drive, you connect two cables—a DC power cable and
an interface cable—to the back of the drive. Your drive’s power input
connector (to which you connect the DC power cable) resembles the
following connector.
Power Cable Connector
The drive’s interface connector is a card-edge connector or a header
connector, as shown in the following figure.
1power cable
2 power input connector
2
1