Carrier 69NT40-521 Refrigerator User Manual


 
ivT-268-07
TABLE OF CONTENTS (CONTINUED)
Section Page
6.26 THERMOSTATIC EXPANSION VALVE 6-26................................
6.27 CONTROLLER/DATACORDER 6-28......................................
6.27.1 Controller/DataCORDER Programming Procedure 6-29..............
6.27.2 Controller Trouble-Shooting 6-29..................................
6.28 WATER-COOLED CONDENSER 6-30.....................................
ELECTRICAL WIRING SCHEMATIC AND DIAGRAMS 7-1........................
7.1 INTRODUCTION 7-1...................................................
INDEX Index-1...................................................................
LIST OF ILLUSTRATIONS
Figure Page
Figure 2-1 Refrigeration Unit -- Front 2-1.......................................
Figure 2-2 Refrigeration Unit -- Rear (Panels Removed) 2-3......................
Figure 2-3 Compressor Section 2-4............................................
Figure 2-4 Condenser Section 2-5.............................................
Figure 2-5 Units with Receiver 2-6.............................................
Figure 2-6 Units with Water-Cooled Condenser 2-7..............................
Figure 2-7 Control Box on Units with a Single-Speed Compressor 2-8.............
Figure 2-8 Control Box on Units with a Two-Speed Compressor (Optional) 2-9......
Figure 2-9 Power Autotransformer (Optional) 2-12................................
Figure 2-10 Refrigeration Circuit with Receiver 2-15................................
Figure 2-11 Refrigeration Circuit with Water-Cooled Condenser (Optional) 2-17.......
Figure 3-1 Micro-Link 2i Controller/DataCORDER Module 3-1.....................
Figure 3-1 Key Pad 3-4......................................................
Figure 3-2 Display Module 3-5................................................
Figure 3-3 Standard Configuration Report Sample 3-34...........................
Figure 3-4 Controller Set Point BELOW --10_C(+14_F), or
-- 5 _C(+23_F) optionally 3-35.........................................
Figure 3-5 Controller Set Point ABOVE --10_C(+14_F), or
-- 5 _C(+23_F) optionally 3-35.........................................
Figure 3-6 Two-Speed Compressor Speed Change Logic -- Perishable Range Only 3-36
Figure 3-7 Two-Speed Compressor Speed Change Logic -- Frozen Range Only 3-37.
Figure 4-1 Cooling in High Speed with Two-Speed Compressor 4-5...............
Figure 4-2 Cooling in Low Speed with Two-Speed Compressor 4-7................
Figure 4-3 Cooling with Single-Speed Compressor 4-9...........................
Figure 4-4 Heating Mode 4-11.................................................
Figure 4-5 Defrost 4-13.......................................................