Filter
Top Products
Table 9-5 - 335-3260 to Valve Connection Information
Wire on Valve Cable
335-326
0
Emerson
Fl
ow Con-
trols ESR
Emerson
Flow Con-
trols ESV
Sporlan
SE
I&CDS
Pin # Color
1 Red Red Blue Red
2 Black Blue Red Green
3 Blue Black Black Black
4 Green White White White
5 White Yellow
6 Brown
9-18 • E2 RX/BX/CX I&O Manual 026-1614 Rev 4 5-JAN-2013
9.4 CCB Case Controllers
For information on retrofitting E2s in RMCC stores
with CCBs, refer to Technical Bulletin #026-4119. For
other information about CCB wiring, hand-held terminal
programming and operation, refer to the CCB Installation
Manual (P/N 026-1110).
9.5 ESR8 and MultiFlex
ESR Valve Output Wiring
ESR8 Boards (Discontinued)
For ESR8 boards, the stepper valves are wired to the
board by connecting the four-conductor wire from the
stepper valve to a connector plug and then plugging in to
one of eight jacks along the top of the board
Figure 9-19.
Use the cable harnesses supplied with the valves or use
Belden #9418 four-conductor 18AWG wire.
NOTE: A wire run may not be longer than 150
ft. using Belden #9418.
If the stepper valves have block-style connectors, cut
the ends
off and attach the terminal plugs supplied with the
ESR8 to the wire ends.
Figure 9-19 - ESR8 Valve Wiring
WHITE
BLACK
BLUE
RED
S
TE
P
P
E
R
V
A
L
V
E
TOP OF BOARD
Pin 1
Emerson
Flow
Controls ESR
NOTE: For Sporlan CDS, wire the same as
Emerson Flow Controls ESR, but use green
wire in
place of blue wire.
MultiFlex ESR Board
The stepper valves are wired to the board by connect-
ing the stepper valve harness to one of the eight screw ter-
minal connectors along the top of the board (Figure 9-20)
and matching the wire colors to the legend on the connec-
tors. Use the cable and cable harnesses that are supplied
wi
th the valves.
Figure 9-20
- ECT Flow Valve and MFlex ESR Board Wiring
ECT Flow
Stepper Valve
MultiFlex ESR Board w/ Eight
Screw Terminal Connectors
(P/N 810-3199)
Stepper Valve
Harness
WHITE
BLACK
RED
BLUE
Match wire colors to
silk screen legend on
board terminals