Filter
Top Products
Echelon Devices Mounting • 3-5
3.3 Echelon Devices
3.3.1 CC-100 Case Controller and
CS-100 Case Circuit Controller
Generally, the case controller will be mounted within
the raceway or on top of the case. If a controller must be
replaced or installed in the field, it should be located based
on the specific design of the case.
Figure 3-13
- CCB Mounting Dimensions
3.00"
2.00"
0.50"
0.50"
8.05"
8.95"
O 0.18“
TYP 2 PLACES
26502032
CONTROLLER
(TOP VIEW)
CONTROLLER
(SIDE VIEW)
2.25"
O 0.25"
TYP 2 PLAC ES
0.25"
0.25"
3.3.2 MultiFlex ESR
The MultiFlex ESR is supplied with a snap-track. If
the ESR8 is supplied without an enclosure, it is supplied
with 0.500” long metal stand-off dowels that are pressed
into the mounting holes in the board.
Figure 3-14
- Mounting Dimensions for the MultiFlex ESR
26501055
3.50"
4.00"
10.00"
4.75"
TYP 2 PL
O 0.220"
TYP 6 PL
MULTIFLEX ESR BOARD
9.50"
WEIGHT 9.4 OZ.
3.3.3 TD3
The TD3 temperature display is almost always
mounted by the OEM as part of the construction of the
refrigerated cases. As such, field installations of TD3s are
rare.
TD3s are typically flush mounted on the front of a
refrigerated
case in such a way as to be fully visible from
the sales floor. A hole one inch in diameter must be drilled
into the case to allow the TD3’s wiring harness to extend
into the case and connect to the network, the power source,
and the case-mounted probes. Figure 3-15 shows the
mounting dimensions of the TD3.
Figure 3-15 - TD3 Mounting Dimensions
3.4 COM3 Internal
Modem Plug-In Card
(P/N 638-3362)
The E2’s COM3 Plug-In card mounts on the PIB
(Figure 3-16). For more information on the modem/com-
munication expansion card, see Section 4.3.3, COM
3
Internal Modem Plug-In Card (P/N 638-3362).
Figure 3-16
- COM3 Internal Modem in E2