Agilent Technologies E1441A Oven User Manual


 
Agilent E1441A SCPI Command Reference 129
Chapter 3
*SRE?
*SRE? queries the Status Byte Enable register. The function generator returns a
decimal value that corresponds to the binary-weighted sum of all bits set in the
register.
*STB?
*STB? returns the value of the Status Byte Register. Bit 6 (decimal weight 64) is set
if a service request is pending.
Comments Coupled command: No
Related commands: *SRE
*RST Condition: none
*TRG
*TRG causes the Agilent E1441A to trigger if the TRIG:SOUR is BUS. Triggers are
used to start Burst Mode and Sweep Mode only.
Comments Coupled command: Yes
*RST Condition: TRIGger:SOURce IMMediate
*TST?
*TST? causes the Agilent E1441A to execute its internal self-test and returns a value
indicating the results of the test.
A zero response indicates that the self-test passed. Any non-zero response indicates
that the test failed. Use the SYST:ERR? command to read the error and description
from the error queue. Note the error number and description returned in the error
message. See Appendix B, Error Messages, for information on interpreting the error
number and description response(s).
The settings for all SCPI commands are unchanged by this command.
Comments Sending a Device Clear interface command to the Agilent E1441A while
self-test is executing may generate self-test errors.
Coupled command: No
*RST Condition: none
*WAI
*WAI causes the Agilent E1441A to wait for all pending operations to complete
before executing any further commands.
Comments Related commands: *OPC, *OPC?