Agilent Technologies E1441A Oven User Manual


 
130 Agilent E1441A SCPI Command Reference
Chapter 3
Agilent E1441A Power-On and Reset State
Note The power-on state will state will be different if you have enabled the
auto-recall mode. See “MEMory:STATe:RECall:AUTO OFF | ON | 0 | 1”
on page 85.
Feature Power-On and Reset State
Output Configuration
Function Sine wave
Frequency 1 kHz
Amplitude (into 50 ohms) 100 mV peak-to-peak
Offset 0.00 Vdc
Output Units Volts peak-to-peak
Output Termination 50 ohms
Modulation
AM Carrier Waveform 1 kHz Sine wave
AM Modulating Waveform 100 Hz Sine wave
AM Depth 100%
FM Carrier Waveform 1 kHz Sine wave
FM Modulating Waveform 10 Hz Sine wave
FM Peak Frequency Deviation 100 Hz
Burst Carrier Frequency 1 kHz Sine wave
Burst Count 1 cycle
Burst Rate 100 Hz
Burst Starting Phase 0 degrees
FSK Carrier Frequency 1 kHz Sine wave
FSK"Hop" Frequency 100 Hz Sine wave
FSK Rate 10 Hz
Modulation State Off
Sweep Start / Stop Frequency 100 Hz / 1 kHz
Sweep Time 1 second
Sweep Mode Linear
Triggering Operations
Trigger Source Internal
Calibration
Calibration State Does not change with *RST or
power-down. See page 74