Agilent Technologies E1441A Oven User Manual


 
Agilent E1441A SCPI Command Reference 91
Chapter 3
:ADJust?
PHASe:ADJust? queries the phase offset setting. Returns the phase offset value in
radians (even if you specify the phase offset in degrees).
:REFerence
PHASe:REFerence sets the zero-phase reference point upon command execution.
This command does not change the phase offset as set with the
PHAS:ADJ command
but only changes the phase reference. There is no query form to this command e.g.,
there is no
PHAS:REF? command.
:UNLock:ERRor:STATe
PHASe:UNLock:ERRor:STATe OFF|ON enables or disables the generation of an
error if phase-lock is lost. The default setting is disabled (OFF). The setting is
stored in volatile memory.
Comments When you have enabled (ON) the unlock error state and phase-lock is lost,
error 580, "Phase-locked loop is unlocked" is generated.
:UNLock:ERRor:STATe?
PHASe:UNLock:ERRor:STATe? queries the state of unlock error generation.
Returns "0" if it is disabled (OFF) or "1" if it is enabled (ON).