Filter
Top Products
142 Agilent E1441A Error Messages
Appendix B
-108 Parameter not allowed
More parameters were received than were expected for the command.
You may have entered an extra parameter, or you added a parameter to a
command that does not accept a parameter. Example: APPL? 10
-109 Missing parameter
Fewer parameters were received than were expected for the command.
You omitted one or more parameters that are required for the command.
Example: OUTP:LOAD
-112 Program mnemonic too long
A command header was received which contained more than the maximum
12 characters allowed. Example: OUTP:SYNCHRONIZATION ON
-113 Undefined header
A command was received that is not valid for the function generator. You
may have misspelled the command or it may not be a valid command. If you
are using the short form of the command, remember that it may contain up
to four letters. Example: TRIGG:SOUR BUS
-121 Invalid character in number
An invalid character was found in the number specified for a parameter
value. Example: *ESE #B01010102
-123 Exponent too large
A numeric parameter was found whose exponent was larger than 32,000.
Example: BMOD:NCYC 1E34000
-124 Too many digits
A numeric parameter was found whose mantissa contained more than 255
digits, excluding leading zeros.
-128 Numeric data not allowed
A numeric parameter was received but a character string was expected.
Example: DISP:TEXT 123
-131 Invalid suffix
A suffix was incorrectly specified for a numeric parameter. You may have
misspelled the suffix. Example: SWE:TIME 0.5 SECS
-138 Suffix not allowed
A suffix was received following a numeric parameter which does not accept
a suffix. Example: BM:PHAS 10 DEG (this command does not allow a
suffix).
-148 Character data not allowed
A discrete parameter was received but a character string or a numeric
parameter was expected. Check the list of parameters to verify that you have
used a valid parameter type. Example: DISP:TEXT ON