Filter
Top Products
Wallboard Installation and Maintenance INDeX Wallboard 10
INDeX Contact Centre Modules Page 104
Installation & Maintenance 38HBK00001SCM - Issue 11 (05/01)
Serial Connection and Configuration
An RJ45 junction box is provided as standard, alternatively if required an RJ45
coupler and 2 way adapter can be used. The serial cable is normally connected to
the logic board for RS485 operation, check label on rear of display for specific
configuration. The serial communications lead from the PC is connected to the
junction box as shown later in this manual. Modifications to the network numbers
and baud rates can be done by following section 2.3 below, but changing the dip-
switch settings as per Figure 5.
Fig. 10
1. RS232 Connection 2. RS485 Connection 3.Dip-Switches
Fig. 11
To set the network number requires access to the INDeX Wallboard 10 logic board
as explained above and Fig 5.
To address individual displays in a network, a network number can be set on the
dip-switch on the logic board. Network 0 is a general address and will accept all
data from the host system. The network number is set using switches 1,2,3 and 4.
Dip-switch Number
1234Network
OFF OFF OFF OFF 0
ON OFF OFF OFF 1
OFF ON OFF OFF 2
ON ON OFF OFF 3
OFF OFF ON OFF 4
ON OFF ON OFF 5
OFF ON ON OFF 6
ON ON ON OFF 7
OFF OFF OFF ON 8
ON OFF OFF ON 9
ETC….