Filter
Top Products
Wallboard Installation and Maintenance INDeX Wallboard 10
INDeX Contact Centre Modules Page 107
Installation & Maintenance 38HBK00001SCM - Issue 11 (05/01)
Periodic Maintenance & Inspection
Cleaning Display Screen
Time periods between cleaning depend upon local conditions and are at the
discretion of the operator. This routine cleaning can be carried out in the normal
way using a damp and/or dry cloth.
Note:
This screen is specially coated to reduce reflections and although this coating is very durable
misuse or incorrect cleaning procedures can damage it.
Led Illumination Test Inspection
The purpose of this test is to ensure no LED fails to illuminate and should be
checked annually.
Remove the right hand end cheek and carefully slide out the logic control board so
that the dip-switches are accessible. Set switch 8 to ON, inspect the LED display
that will run blocks of Green, Red and Yellow across the display. Look for any LEDs
that fail to illuminate.
Return switch 8 to the OFF position to stop this test.
Led Matrix Scanning Inspection
The purpose of this inspection is to ensure the LED matrix is being scanned
correctly. Remove the right hand end cheek and carefully slide out the logic control
board so that the dip-switches are accessible.
Set switch 7 to ON, Yellow diagonal stripes will run across the display. Check that
these stripes are straight and that Yellow is the only colour displayed. Having
completed this visual inspection return switch 7 to OFF and ensure that all switch
settings comply with system requirements for baud rate and wallboard network
address number.