Filter
Top Products
5 - 46
5.2 Communication Setup
5.2.4 Setting on GT Designer2
5.2.4 Setting on GT Designer2
(1) Ethernet setting method
(a) Operation procedure
When either of the following operations is performed, the Ethernet dialog box is displayed.
• Select [Common] [Ethernet] from the menu.
• Double-click (Ethernet) in the workspace.
(b) Ethernet dialog box
Item Description
Ethernet setting list
Set the N/W No., PLC No., and others for controllers to be monitored by GT SoftGOT1000.
Up to 128 can be set.
N/W No. Set the network No. for the controller.
PLC No. Set the PLC No. (station No.) for the controller.
Type
Select the type of controllers (QnUDE(H), QJ71E71, AJ71QE71, AJ71E71, Q17nNC, CRnD-700).
For the MELDAS C6/C64, set the type of the Ethernet module to "AJ71QE71".
IP address Set the IP address assigned to the controller.
Port No.
Set the port No. for the controller.
For the E71, set the port number of the connection target E71 set in the sequence program.
Fixed to "5006" when [Type] is [QnUDE(H)].
Fixed to "5001" when [Type] is [QJ71E71], [AJ71QE71], or [CRnD-700].
Communication Fixed to UDP.
Add Used to add the Ethernet setting to the list.
Copy Used to copy the selected Ethernet setting to the end of the list.
Delete Used to delete the selected Ethernet setting.
Delete All Used to delete all Ethernet settings.
Set to Host
Used to set the selected Ethernet setting to the host.
(When the setting is set to the host, the " * " mark is displayed.)