Filter
Top Products
3.3 Precautions
3.3.1 Precautions for using the GT Soft GOT1000
3 - 6
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SCREEN
CONFIGURATION
5
OPERATING
METHOD
6
FUNCTIONS
7
INTERNAL DEVICE
INTERFACE
FUNCTION
8
TROUBLESHOOTING
APPENDICES
5 Logging, advanced recipe, operation log, operator authentication
The logging information, advanced recipe information, operation log information, and operator info.
management cannot be displayed with the utility.
For using the logging information, advanced recipe information, operation log information, and operator
info. management, set special function switches.
For special function switches, refer to the following manual.
GT Designer2 Version2 Screen Design Manual
6 Printer to output function
(1) Hard copy output destination
Hard copy output destination can be specified on GT Designer2 or GT SoftGOT1000.
Settings that are required for each hard copy output destination are shown below.
(a) In the case [Printer] is selected as the output destination on the Hard copy setting screen of GT
Designer2.
-: Setting ineffective
(b) In the case [File] is selected as the output destination on the Hard copy setting screen of GT
Designer2
.
-: Setting ineffective
Refer to the following for hard copy functions.
GT Designer2 Version Screen Design Manual
Refer to the following for Page Setup.
6.2.3 Performing page setup
Refer to the following for Environment Setup.
5.3 Environment Setup
Hard copy output Setting at GT SoftGOT1000
File save destination (Hard
copy (File Save))
Printing
[Print to printer (Hard Copy
Function)] on the Page
Setup screen
[File Output (Hard Copy
Function)] on the
Environment Setup screen
Virtual A Drive
(GT1sgHardcopy)
Yes Check -
Virtual A Drive
(GT1sgHardcopy)
No Uncheck -
Hard copy output Setting at GT SoftGOT1000
File save destination (Hard
copy (File Save))
Printing
[Print to printer (Hard Copy
Function)] on the Page
Setup screen
[File Output (Hard Copy
Function)] on the
Environment Setup screen
Virtual A Drive
(GT1sgHardcopy)
No - Select [Default].
The save file destination that
was specified on the Hard
copy setting screen of GT
Designer2
No - Select [Project Data Setting].