Filter
Top Products
5.2 Communication Setup
5.2.3 How to Set Up the Ethernet Connection
5 - 11
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SCREEN
CONFIGURATION
5
OPERATING
METHOD
6
FUNCTIONS
7
INTERNAL DEVICE
INTERFACE
FUNCTION
8
TROUBLESHOOTING
APPENDICES
(3) Q parameter setting (Setting on GX Developer)
Set the Built-in Ethernet port for the Q parameter setting. (multiple connection only)
Operation settings
To make communications with GX Developer, ask the person in charge of the network about the IP
address setting to confirm, and set the IP address.
Since "any" values may be set to the other items, set them according to the specifications of the
other node and application connected to the Ethernet module.
The following are the operation setting items that may be set to "any" values on GX Developer.
(a) Communication data code
Either "Binary code" or "ASCII code" may be specified.
(b) Initial Timing
Independently of this setting, communications can be made from GX Developer if the PLC
CPU is at a STOP.
(c) Enable Write at RUN time
Independently of this setting, online program correction or device test can be performed from
GX Developer.
Item Setting Screen Examples
Built-in Ethernet port
Open settings