Mitsubishi Electronics SW2D5C-GTWK2-E Frozen Dessert Maker User Manual


 
8 - 9
8.6 Error Code and Error Message List
8.6.1 GOT error code list
8.6 Error Code and Error Message List
8.6.1 GOT error code list
The system alarm detected with GOT is shown below.
Error
code
Error message Action
Channel
No.
storage
303
Set monitor points too
large. Decrease setting
points.
Decrease the number of objects from the displayed screen.
For the number of maximum objects for 1 screen, refer to the
following.
GT Designer2 Version Screen Design Manual
304
Set trigger points too
large. Decrease setting
points.
The number of objects using Sampling/Cycle during ON/
Cycle during OFF exceeds 100.
Decrease the number of objects.
306
No project data.
Download screen data.
The project data is not downloaded to the built-in flash
memory.
Download the project data to the built-in flash memory.
307 Monitor device not set
The monitor device of the object is not set.
Set the monitor device of the object.
308
No comment data.
Download comment.
The comment file does not exist.
Create the comment file and download to GOT.
309
Device reading error.
Correct device.
The error occurred when reading a continuous device.
Correct the device.
310
Project data does not
exist or out of range.
1. Specified base screen / window screen does not exist in
the project data.
2. Specified base screen / window screen is out of the
permissible area. Specify the existing base screen /
window screen.
311
No. of alarm has
exceeded upper limit.
Delete restored alarm.
The number of alarm histories that can be observed by the
alarm history display function has exceeded the maximum
points.
Delete the restored history to decrease the number of alarm
histories.
312
No. of sampling has
exceeded upper limit.
Delete collected data.
The collection frequency exceeded the upper limit when
"Store Memory" and "Accumulate/Average" were set in the
scatter graph.
1. Approve "Clear trigger" setup in the scatter graph.
2. Set the "Operation at frequency over time" and "initialize
and continue" in scatter graph.
315
Device writing error.
Correct device.
Error occurred while writing in the device.
Correct the device.