Filter
Top Products
Chapter 5
5-2 Respironics V200 Ventilator Operator’s Manual REF 1057983 A
Setup
5. Analog Port: Pin 12 signals an unsilenced high or medium urgency
alarm. Other pins are used by the Communications Option. Refer to
Chapter 13, “Options and Accessories”.
6. DC Battery Connector: Connection source for battery power cord.
7. AC Inlet: Connection for AC power cord.
8. Humidifier AC Circuit Breaker: Circuit breaker for AC power applied to a
humidifier.
9. Circuit Breaker Cover: Circuit breaker cover (not shown) protects the
Humidifier AC Circuit Breaker and Mains Circuit Breaker switches.
10. Mains Circuit Breaker: Circuit breaker for main AC circuit.
11. Humidifier AC Outlet: Connection for Humidifier AC power cord.
12. Air Inlet Duct and Filter: Filters room air drawn into the ventilator
internal air source.
13. Elapsed Time Meter: Records time when the Power On/Off Switch is on
().
14. O
2
Inlet Connector: Connection for oxygen hoses.
15. O
2
Inlet Filter and Water Trap: Filters oxygen entering the ventilator.
16. Potential Equalization Connection: Common grounding point.
17. Cooling Fan Inlet: Allows cooling air to enter the ventilator.
WARNING: The cover plate for the PCMCIA slot at the back of the ventilator must be
replaced after the adapter and card are installed. This is to protect the
ventilator.
CAUTION: The PCMCIA card should only be removed by trained service personnel
once power to the ventilator is off.
WARNING: AC power is applied to the humidifier from the ventilator humidifier outlet
(only available on 100-120 VAC ventilators). Under no circumstances does
the Respironics V200 Ventilator provide control for the humidifier. To ensure
patient safety, it is important that any humidifier used with the ventilator
include an acceptable temperature control and monitoring mechanism, as
well as a temperature display and appropriate alarm capabilities (refer to
ISO 8185).
CAUTION: To avoid the possibility of damage to the ventilator, do not connect a
humidifier whose maximum rating exceeds 3 amps. Ensure that the
humidifier power cord is free from defects and any obvious wear, and is
properly grounded. A humidifier connection is only available on 100-
120VAC ventilators.