Chapter 5
5-4 Respironics V200 Ventilator Operator’s Manual REF 1057983 A
Setup
Connecting AC Power Cord Instructions
Refer to Figure 5-2.
• Tools Required: Small Phillips screwdriver
1. Ensure that the ventilator is properly positioned on a secure table top,
wall mount, or pedestal.
2. Connect the AC Power Cord (1) to the AC inlet (3) located on the rear
panel. (Refer to Figure 5-1.)
3. After cord is fully inserted, tighten the retaining bracket screw (2) so
that the power cord cannot be inadvertently disconnected from the
ventilator.
Power On/Off The ON/OFF ( / ) switch is located in the lower portion of the front panel,
and is recessed to avoid inadvertent access.
When the switch is in OFF ( ) position, the ventilator does not provide
mechanical ventilation. If the AC plug is connected and the Mains circuit
breaker (refer to Figure 5-1) is ON ( ), AC power is active and the green
Mains circuit indicator on the front panel, is illuminated.
Figure 5-3: On/Off Switch
Inop
Vent
Safety
Valve
Power On/
Off Switch